The suction pipe should also be placed outdoors when designing the injection screw air compressor compressed air station. The practice is as follows: (1) A rubber plate of the same size and a thickness of about 1020 mm is placed on the air inlet of the air compressor, and a flange of one end of the suction pipe is placed on the rubber plate. (2) The other end of the suction pipe extends out of the outdoor suction muffler. At this time, measures should be taken to prevent rain and debris.

Determining the reasonable compressed air dew point The temperature at which the humid air cools to saturation at a certain pressure is called the dew point. When the air temperature reaches the dew point, water droplets are deposited. Water droplets in the air can affect product quality or equipment operation. Modern industry has requirements for the compressed air dew point used. In order to reduce the dew point of the compressed air, it is necessary to consume the already compressed compressed air or electric energy, thereby consuming energy and increasing the production cost of the enterprise. The heat-free regeneration process produces dry compressed air. The amount of dry compressed air consumed by the regenerative desiccant is about 13% of the air volume. The electric energy consumption of the dry compressed air produced by the freezing process increases with the decrease of the dew point. The lower the dew point, the lower the dew point. The more expensive, the more expensive the equipment you need. In order to reduce the project cost and save energy, the compressed air dew energy saving point should be determined in different situations.

According to the process requirements, certain industries, such as medicine, electronics, high-purity materials, etc., are used for agitation and product purging. For the control of product quality, low dew point compressed air is required, and the required dew point can reach -40-70e ( Atmospheric pressure). The compressed air dew point at this time should meet the process requirements.

Straight Line Wire Drawing Machine


LZ8/400 straight line wire drawing machine(MIG from 2.0 to 0.8mm)

One: main technical parameters

1. The maximum feed-in of the straight type:≤Ф2.0 mm

2. Tensile strength: ≤750Mpa

3. Material rod:ER50S-6 ER70S-6 and so on.

4. Minimum outlet diameter:Ф0.8mm

5. Equipment center height; 900mm

6. Synchronous take-up of spool, with tension frame

7. Wire drawing speed: 20-22m/s, normal drawing speed: 18m/s

Two: Equipment composition:

800 spool pay-off + LZ8/400 straight line wire drawing machine + degrease cleaning machine+tension stand + 630 spool take-up


A: 800 spool pay-off

B: LZ8/400 wire drawing machine

1: Fully enclosed type, with dust removal port, noise ≤82db, fast speed

1) Motor: â‘ Host: 8-15KW motor

2) Block : ① Block diameter: Ф400mm of straight type

â‘¡ Material of reel: ZG45~55 steel,

The straight line wire drawing machine can process the MIG welding wire,carbon wire,flux cored wire and other alloy wire and so on.


2.OPERATION VOLTAGE: 220/400V 50 CYCLE

3.THE FIRST YEAR IS FREELY SERVICE(BUT EXCEPT THAT BREAK THE MACHINE OR PARTS DELIBERATELY),THE SECOND AND THIRD YEAR JUST PAY THE PARTS COST

THE SELLER MUST OFFER THE LIFE-TIME SERVICE TO ALL MACHINE LINE.

4.THE SELLER MUST GUARANTEE TO PRODUCE THE GOOD QUALITY FINISHED WIRE.




Straight Line Wire Drawing Machine,Straight Line Drawing Machine,Straight Line Stainless Steel Drawing Machine,Stainless Steel Wire Drawbench

Jiangyin Wanyi Machinery CO.,Ltd , https://www.wydrawmachine.com