Hydraulic metal machine is mainly applicable to steel mills, recycling and processing industries and non-ferrous metal smelting industries. Hydraulic Baling Machine can squeeze all kinds of metal scrap (steel shaving, waste steel, waste aluminum, waste copper, waste stainless steel and scrap automobile waste, etc.) into cuboid, octagon, cylinder and other shapes of qualified charge, which can reduce the transportation and smelting cost, and improve the speed of furnace. It is mainly used for cold pressing under normal conditions for scrap metal scraps, scrap steel scraps, waste oil tank, disassembling car shell and other metal scraps with a thickness of less than 3mm. Cold pressed into blocks for easy storage and transportation or furnace.
Features:
1) Hydraulic drive, smooth and noiseless work, fast extrusion speed, large extrusion force, compact package block, not easy to be scattered.
2) high quality national standard steel plate with advanced welding technology to make the mechanical parts strong and durable, low failure rate, long service life.
3) the oil cylinder seal is imported glyd ring, good sealing performance, strong pressure resistance.
4) Convenient installation, small floor space, no foundation, foot, etc. Simple operation, detachable and PLC automatic mode.
5) Cold extrusion will not change the metal material and increase the utilization rate.
Metal Shavings Baler, Scrap Metal Baler, Waste Metal Baler, Sheet Metal Baler, Metal Scraps Baler Jiangyin Metallurgy Hydraulic Machinery Factory , https://www.eco-balingmachine.com
Regular maintenance of the car is very important. If the tire is flat, the spark plug wears, and the air filter becomes blocked, it can cause gasoline damage. In addition, to keep the engine fresh, the trick is to select the sliding oil and remove coke.
1, pay attention to check the lack of tire system tire pressure will increase the friction between the tire and the ground, increase fuel consumption, so always check the tire pressure, different models and tires have different air pressure standards. In addition, if the tire is worn out severely, slippage will occur and fuel consumption will increase. If necessary, replace the tire.
2. Pay attention to the frequent inspection of the brake system. Some vehicles will experience a slight drag brake, including hand brakes, which will increase the load of the car when driving and will increase fuel consumption, so regular inspections are required.
3, regular maintenance, replacement parts Air filters, fuel filters, oil filters, etc. Every need to replace every 5,000 km, because the air filter plug will cause reduced gas volume, resulting in inadequate combustion of gasoline, reducing fuel efficiency.
The wear of clutch plates and clutch pressure plates and the use of spark plugs for too long can also lead to increased fuel consumption. Therefore, they must be replaced regularly.
4, to reduce the load to minimize the idle in the trunk without the use of debris.
Driving skills The transmission of vehicle power is first transmitted from the engine to the transmission, and then transmitted from the transmission shaft to the driving wheel. The amount of power output depends on the magnitude of throttle pedaling. From a fuel-saving perspective, with the minimum power output, achieving the fastest speed, of course, will have the highest efficiency.