Wrecker Transmission Tips Solar Panel Cleaner Machine,Solar Plate Cleaning Machine,Panel Cleaning Machine,Solar Plate Washing Machine Taian Longye Import And Export Trade Co.,ltd , https://www.lydrillingrigfactory.com
With automatic transmission, people can complete the driving of the car between the throttle and the brake. It is very easy. If the owner neglects to maintain the automatic transmission, the delicate automatic transmission is prone to malfunction.
Tip 1:
When the wrecker is parked for a long time, the shift lever is still hung in the D range.
When waiting for a signal or traffic jam, if the time can maintain the shift lever in the D range within one minute, but for a long time, it is better to swap in N (neutral) and tighten the parking brake, otherwise it will The oil temperature of the transmission is increased, and the oil is easily deteriorated.
Tip 2:
When driving at high speed or downhill, shift the gear lever to slide in the N range.
In order to save fuel, some drivers shift the shift lever to N-block to coast when driving at high speed or downhill, which is likely to burn the transmission. When the long slope is actually required to slide, the shift lever can be kept in the D block, but the engine can not be turned off.
Tip 3:
The engine is started in the gear outside the automatic transmission P or N.
Starting the engine outside the range of P or N, although the engine is not running, it is possible to burn out the neutral start switch of the transmission. Therefore, the engine can only be started in P or N range. Before starting the engine, make sure that the shift lever is in P or N range.
Tip 4:
The parking brake is not used when the ramp is parked.
When parking on the slope, there is a potential safety hazard if the parking brake is not used. Although the parking lock mechanism provided in the P position of an automobile equipped with an automatic transmission is generally seldom ineffective, it may cause accidents if it fails. .
Tip 5:
As long as D block starts, you can increase the throttle to shift to high speed.
This practice is wrong. Because the shift operation should be "advanced early-advanced throttle, step on the throttle down ahead of schedule." That is, after the start of D block, keep the throttle opening 5%, accelerate to 40km / h, fast loose throttle, can be increased to a gear, and then accelerated to 75km / h, loose throttle can increase a gear. When driving down, press the driving speed and press the throttle slightly to return to the low gear. However, it must be noted that the throttle must not be stepped on. Otherwise, the low gear will be forcibly engaged and the transmission may be damaged.