Introduction: Glass engraving machine is a kind of engraving machine. It is used in crafts, advertisements, molds, architecture, printing and packaging industries. Glass engraving machine is mainly used for glass and lens processing, that is, on flat glass, marble and other materials. 3D, embossed, single-line body and other engraving operations.

Glass engraving machine maintenance and care matters

The failure of the glass engraving machine requires timely maintenance, and it is usually necessary to pay attention to maintenance of the machine. When the glass engraving machine is not engraved, it may be due to the following reasons:

1. Whether the electricity

2. Has the serial port of the computer been connected to the engraving machine with a serial cable? Is the connection secure?

3. The output port setting of the software is consistent with the actual connection

4. Whether to send the correct data format to the engraving machine

Solve the simple method of glass engraving machine failure:

1. Restart the computer and engraving machine

2. Regularly lubricate the long shaft with butter, and use a uniform force when loading and unloading the tool. Always clean the inside of the residue and wipe the oil properly.

3. Allow the motor to run for two minutes before turning on the machine and then remove the knife. Clean up the machine every six months.

4. When conducting electrical maintenance inspections, be sure to shut off the power and wait until the monitor has no display and the main circuit power indicator is off before proceeding.

5. The glass engraving machine must be inspected for fasteners for about three months. The connection screws on the two sides of the gantry, the fastening screws for the screw nut, and the fastening screws on the two sides of the motor are used for fastening.

NEW ENERGY and TECHNOLOGY

New energy for using

Henan Youlong Petroleum Engineering Technology Co.,Ltd , https://www.youlongenergy.com