Die cutting machine is also known as a beer
machine and CNC punching machine, it is mainly used for the corresponding
non-metallic materials, sticker, EVA, double-sided adhesive, electronics,
mobile phones, pads and other die-cut (full cut or kiss cut), the indentation and
bronzing job fit, automatic waste discharge, die-cutting machines use blades,
metal molds, steel wire (or steel plates carved into the template) to apply
some pressure by stamping version, printed materials or cardboard rolled and
cut into a certain shape. Cutting machines are very important equipment in the
post press packaging molding process.
Die-cutting Machine Working Principle
Die Cutter,Die Machine,Die Cutting Machine,Electric Die Cutting Machine Suzhou Flying Man Assembly Automation Co., Ltd. , https://www.flyingmans.com
According to the statistics of China Association of Automobile Manufacturers, in the first half of 2007, cumulative sales of the 10 pickup brands registered in the first half of the year were 84,755, and the top three were sales of Great Wall, ZTE, and Zhengzhou. The self-owned brands accounted for nearly 80% of total sales.
In the first half of 2007, the Great Wall pickup sold 25,016 vehicles, accounting for 29.5% of the entire pickup market. The sales of ZTE and Zhengzhou Nissan were 14,287 and 13,033, respectively, which accounted for 16.9% and 15.4% of the market share, respectively. The ranking followed was Jiangling, Futian, Huanghai, and Qingling, with sales of 11,565 vehicles, 6,788 vehicles, 5,360 vehicles, and 4,643 vehicles respectively.
Working principle of die cutting machine is to use the steel knife, metal molds, steel wire (or steel plate engraving templates), the pressure applied by embossing version, make the printed materials or cardboard rolled and cut into a certain shape. If the pressure of the entire printed materials cut into a single graphics products, this is called die-cutting; if use the two templates of upper and lower by the mold to heat up to a certain temperature, to leave the bending groove marks is called indentation on the surface of the printed products stamping having a three-dimensional effect of the pattern, or font called bronzing; if use a substrate to multiplex on another substrate, this is called bonded; excluded from inter authentic outside the remaining portion of said above collectively referred to as die-cutting technology for waste; the working principle of the automatic die cutting machine is the feeding machine feeder parts sent the paper to the front and the regulatory and side provisions bit, and then the tooth row send the paper to the die secondary positioning for cutting, after die-cutting and then again from teeth row to the platoon served stripping agencies, after stripping and then enter the delivery section, thus completing a die-cutting job.
