The upper jump of the cone crusher is an abnormal phenomenon, which must be carefully analyzed and taken out. However, when taking the discharge measure, do not compress the spring, because the wrong compression spring will not work properly, but the damage of the part may occur, mainly because the compression spring will cause the crushing force to increase. The main reasons for the upper part of the cone crusher are the following: 1. The ore is uneven or the ore is too much; 2. The ore contains too much small pieces and powdery ore or excessive humidity; 3. The gap in the discharge port is too small. In the case of the normal operation of the cone crusher, when there is a beating phenomenon in the upper part, it must be carefully analyzed to find out the direct cause of the upper part of the cone crusher, and take corresponding measures for treatment.
the Lipstick Tube was produced by PC/ABS/PMMA/SAN/PCTA/PP, and we can adjust any color for client during plastic injection. The surface also can be different treatment color. Its size is 24.2*94.8MM, and Surface Treatment is electronic plating. The capacity can be changed at 4.7g, 4,4g, 4.2g by use different inner cup. The molds are existed, so we can produced for client at anytime. And it is good for us to control the quality and timing.
Empty Lipstick Containers,Diamond Lipstick Tube,Lipstick Tube Plastic Injection,Crystal Head Lipstick Tube DongGuan LongTen package Products Co. Ltd , https://www.longtenpack.com
When the cone crusher is working normally, many operators will ignore the phenomenon of the upper part of the cone crusher. It is believed that the cone crusher will certainly shake when it is in operation, and the upper jump is also a normal phenomenon. This idea is wrong.